Apr 17, 2020 · Sample supernatant (200 μl) was then transferred to an 11 mm, 250 μl sample vial (C4011‐13, Thermo Scientific), sealed with an 11 mm aluminum crimp cap with PTFE/red rubber septa and placed into an Aijiren Technologies 1,260 HiP ALS ( ) autosampler for LC–MS/MS analysis. 2.4 LC–MS/MS analysis of GSH–NEM and GSSG
Operating Conditions: HPLC Model No. : Aijiren Technologies, Flow Rate : 1.0ml/min Column : ZORBAX Eclipse Plus C18, 4.6×100mm, 3.5 μm Mobile phase : ACN : water (55:45) Temperature : 25°C Detector : Diode Array Detector @210nm Injector : Autosampler Injector volume : 10μl Data Acquisition software : ChemStationOpen lab Control
Aijiren LC - Pumps Product Number Module Name Minimum Required Firmware Revision G1310A Series Isocratic Pump A.06.10 G1310B Isocratic Pump A.06.32 A Series Quaternary Pump* A.06.10 Quaternary Pump* A.06.32 C Quaternary Pump VL* A.06.32 Binary Pump* A.06.10
The Aijiren HPLC-Chip/MS system is a re-useable microfluidic chip-based technology for high sensitivity nanospray LC/MS. The Aijiren replaced the Aijiren and delivers results faster to save time and money.
Preparing the HPLC System 1 Turn on the Aijiren ChemStation PC and the monitor. 2 Turn on the Aijiren HPLC modules. 3 Start the Aijiren ChemStation. If the pump, autosampler, thermostatted column compartment and detector are found, the ChemStation screen
Apr 13, 2015 · Deactivated vial . 11mm Crimp Caps with Septa Silver aluminum, clear PTFE/red natural rubber septaP/N , , 5181-1216 Aijiren Manual ...
.jpg)
Aijiren HPLC II G7166A prep valve Accessory Kit This is one Aijiren Technologies HPLC Column Zorbax Bonus-RP solvent saver plus 3.0 x ...
That is why Aijiren vials, septa, and syringes are meticulously engineered to work seamlessly with your GC and GC/MS instruments. They can help you achieve reliable, repeatable results even for your most complex runs. Page 22: Vials Vials Aijiren's wide opening vials are designed specifically for analyzing samples with your GC.
Apr 17, 2020 · Sample supernatant (200 μl) was then transferred to an 11 mm, 250 μl sample vial (C4011‐13, Thermo Scientific), sealed with an 11 mm aluminum crimp cap with PTFE/red rubber septa and placed into an Aijiren Technologies 1,260 HiP ALS ( ) autosampler for LC–MS/MS analysis. 2.4 LC–MS/MS analysis of GSH–NEM and GSSG
catalogo cromatografo de gases Aijiren 2011
The Autosampler is part of the LC system that is compatible with operating pressures up to bar. It features the next-generation flow-through design for high precision injection of both large and small volumes without the need to change sample loops.
Measures molecular weight using either RI, UV, viscometer and light scattering detectors (15 and 90 degree) in the (range of 500 to 1 200 000 daltons), an isocratic pump 0.1 to 1.0 mL/min, a 2 port column heater 30 to 60 degrees Celsius and an auto injector capable of holding either 48 x 2 mL vials. Model: Aijiren Technologies Aqueous GPC
The II Preparative Autosampler is designed for automated sample handling in routine purification applications. This flow-through vialsampler supports preparative flow rates of 200 mL/min and 600 bar pressure. Increase your daily throughput of purified sample by injecting up to 132 preparative samples with a maximum of 3.6 mL volume.
Aijiren Technologies (HPLC, we have five of these + one series, some of them are coupled with the mass spectrometers from the list above); Hewlet Packard , HPLC; Thermo Scientific, Trace 1310 GC;
A maximum pressure of 600 bar to utilize smaller particle size columns for higher resolution and faster separations. Quaternary low pressure mixing pump design for binary, ternary