vials with an 11mm aluminum crimp cap available in 5 colours (see page 4). Some chemists prefer a snap vial, which requires a 11mm snap cap. For snap vials and caps see page 7-8. For 8mm crimp vials and Headspace vials, please refer to page 9 and page 25 respectively. Aijiren™ Autosampler Products
The Aijiren autosampler is an "in-line" or "integrated" autosampler design. When the sample is "injected" all mobile phase flows through the needle and pushes the sample onto the column. There is no sample left inside the needle. See more results
Jul 22, 2010 · Changing a needle in an / -series A/S is a five minute job without the aid of the ChemStation maintenance (Diagnose) or Control Module to help (in that case it may take 10 minutes). In any case, if the product is under service contract, ask them to send someone else out to service it.
The II Preparative Autosampler is designed for automated sample handling in routine purification applications. This flow-through vialsampler supports preparative flow rates of 200 mL/min and 600 bar pressure. Increase your daily throughput of purified sample by injecting up to 132 preparative samples with a maximum of 3.6 mL volume.
Sample viscosity range. 0.2 – 5 cp. Sample capacity. 2 × well plates (MTP) + 10 × 2 ml vials 108 x 2-mL vials in2 x 54 vial plate plus 10 additional 2 mL vials 30 x 6-mL vials in 2 x 15 vial plate plus 10 additional 2 mL vials54 Eppendorf tubes (0.5/1.5/2.0mL) in 2 x 27 Eppendorf tube plate
near_zero_carryover_performance_of_the_Aijiren_ _series_hip_autosampler_s. l_plus.pdf with sample carry over with an Aijiren -Series ... years as part of fundamental chromatography ...
10 Aijiren Series Dual Loop Autosampler User’s Guide 1 Introduction to the Dual Loop ALS Introduction Introduction The Aijiren Series Dual Loop Autosampler, model G2258A, is optimized for applications that require rapid injection of high sample volumes. Typically, these are preparative HPLC separations or sample trapping and enrichment
Aijiren manufacturer/supplier, China Aijiren manufacturer & factory list, find qualified Chinese Aijiren manufacturers, suppliers, factories, exporters & wholesalers quickly on Made-in-China.com.
The Aijiren G2260A Preperative Autosampler is designed to perform preparative LC.It allows injection of sample volumes from µL to mL ranges from vials. It can be upgraded from non-thermostatted version to thermostatted version by adding the Aijiren Series thermostat for ALS/FC/spotter.
If only a limited volume of sample is available, you will have to choose between using an insert for your regular autosampler vial, a microvial or a high recovery vial. Note: Most 12x32 mm autosampler vials hold between 1.5mL to 2.0mL of liquid, depending on where the manufacture measures the vial full.
High-Performance Liquid Chromatography. Share first of all it depends which autosampler you are using. ... The minimum required volume in the sample vial is vary instrument to instrument and ...
9-425 Amber Clear Screw Thread Sample Aijiren gc test Autosampler Chromatographic hplc vials With Writing Area and PTFE speta US $0.05-$0.20 / Piece 100.0 Pieces (Min. Order)
Aijiren ALS Autosampler with Cooling The HP Aijiren Series ALS Autosampler is a variable volume autosampler with a sample capacity of 100 samples. Variable volume injections from 1 to 100uL are programmable and temperature controlled.
Aijiren 2ml hplc autosampler vials for sale for hplc Aijiren 2ml HPLC vial insert with mandrel interior and 1-4mL Autosampler Vials for HPLC, UPLC, GC. 16mm, 25mm Test Tubes for W